DE`LONGHI disassembly-FP250[1] free download

File name disassembly-FP250[1].pdf

Spares - FP250 Disassembly & re-assembly instructions Page 1 of 7 FP250 The following procedures are aimed to help with dismantling and service repairs. Always disconnect the appliance from mains supply prior to removal of the covers and suitably protect the finish on the casings. Click on the pictures to open a larger version in a seperate window. Remove the base which is secured by four screws. Remove the screw securing the stuffer box cover. Please note the correct route for the supply cord. http://www.kenwoodservice.co.uk/product-files-kar/guide_FP250.htm 30/04/2009 Spares - FP250 Disassembly & re-assembly instructions Page 2 of 7 To remove the drive coupling, steady the motor by placing a screwdriver in the slot at the bottom of the armature shaft, and using pliers turn the drive coupling in a clockwise direction. Remove both PCB screws and the earth screw. Ensure the insulation shield is fitted. http://www.kenwoodservice.co.uk/product-files-kar/guide_FP250.htm 30/04/2009 Spares - FP250 Disassembly & re-assembly instructions Page 3 of 7 Remove the three screws indicated and lift out the interlock assembly. The drainage tube is glued onto the interlock moulding, therefore this complete assembly will be supplied as sub-assembled parts. http://www.kenwoodservice.co.uk/product-files-kar/guide_FP250.htm 30/04/2009 Spares - FP250 Disassembly & re-assembly instructions Page 4 of 7 Remove the three motor retaining screws and switch carrier screw, then lift the motor, PCB, and switch assembly out of the body. The motor, PCB, switch, noise filter and supply cord. http://www.kenwoodservice.co.uk/product-files-kar/guide_FP250.htm 30/04/2009 Spares - FP250 Disassembly & re-assembly instructions Page 5 of 7 The gearbox assembly. Please note correct position for the insulation tabs. These must be glued in position. The bayonet cover is secured by the two screws and one locating lug, as shown. http://www.kenwoodservice.co.uk/product-files-kar/guide_FP250.htm 30/04/2009 Spares - FP250 Disassembly & re-assembly instructions Page 6 of 7 The control knob is secured internally as shown here. Remove the three screws from the cam to remove the control knob. The liquidiser blade hub assembly viewed from below. Turn the coupling in a clockwise direction to remove. http://www.kenwoodservice.co.uk/product-files-kar/guide_FP250.htm 30/04/2009 Spares - FP250 Disassembly & re-assembly instructions Page 7 of 7 Click here to return to the top of the page. Back. http://www.kenwoodservice.co.uk/product-files-kar/guide_FP250.htm 30/04/2009